Upgraded Piig

Every time I looked at the original PiigBox, I knew I’d end up upgrading it to V2 with 3D printed grommits for a better fit and look. So Easter Monday morning I bit the bullet and stripped the speakers out. I intended just replacing the rubber o-rings with 3D printed parts and new bolts.

But it soon became apparent that the rings were well and truley welded (glued) to the speakers and it ripped a very small section of the rubber cone. There was only one thing for it. New speakers. So I raided the store room, and added new bling to the house Piig.

Leave a Reply

Your email address will not be published. Required fields are marked *